Search found 12 matches
- Thu Aug 28, 2008 12:00 am
- Forum: R1100R
- Topic: First gear hard to engage
- Replies: 14
- Views: 4527
Re: First gear hard to engage
I had a similar issue with my 2001 R1100R and I finally figured out that if you push down into 1st gear when coming off neutral and hold the pressure a half second longer that would be normal on most bikes, it stays in gear every time. I think most people are like me and have developed a habit over ...
- Sat Aug 23, 2008 1:22 am
- Forum: R1100R
- Topic: R1100R Suspension Options
- Replies: 1
- Views: 1560
R1100R Suspension Options
Hello insightful and helpful BMW riders I ride a 2001 R1100R with almost 50K on the clock. The springs have sprung on the old girl and it is time to buy some new suspension. What are my options for decent aftermarket products? I'd like something that can be rebuilt down the line as I made the mistak...
- Sat Sep 16, 2006 3:28 pm
- Forum: R1150R (2001-2005)
- Topic: Don't you just hate:
- Replies: 21
- Views: 5604
- Mon Aug 28, 2006 10:44 pm
- Forum: R1150R (2001-2005)
- Topic: Bike shuts off when turning handlebars hard left.
- Replies: 7
- Views: 3245
- Sat Aug 26, 2006 10:17 pm
- Forum: R1150R (2001-2005)
- Topic: Starter interlock?
- Replies: 6
- Views: 2583
To me it is a clear case of failure of the clutch switch. The clutch lever works a small switch, just like the brake lever works the brake lights. If you are in neutral you don't need the clutch to start the engine. If you are in gear, it wants to know the clutch is pulled. if the switch fails, it ...
- Sat Aug 26, 2006 2:34 pm
- Forum: R1150R (2001-2005)
- Topic: Tire Removal Tips and Tricks?? - Both of them simultaneously
- Replies: 15
- Views: 6777
sling that R
I haven't tried this trick with the R, but in the past when I had a project bike in the garage I would a run a couple tie down straps from the joists in the ceiling and hook them to the front and the back of the bike to make a sling. Seemed to work fine and even if I bumped the bike or had to crank ...
- Sat Aug 26, 2006 2:24 pm
- Forum: R1150R (2001-2005)
- Topic: Pinstripes
- Replies: 3
- Views: 2392
- Sat Aug 26, 2006 12:45 pm
- Forum: R1150R (2001-2005)
- Topic: Starter interlock?
- Replies: 6
- Views: 2583
Thanks for the reply - I didn't specify in the original post but I had the stand up. Even when it was new, the bike would not start with the side stand down regardless of the clutch/gearbox position. :( I've been on the bike for 4+ years so whatever changed isn't an operator issue - ask my wife, I'm...
- Sat Aug 26, 2006 10:36 am
- Forum: R1150R (2001-2005)
- Topic: Pinstripes
- Replies: 3
- Views: 2392
R1100RL pic
I didn't do the pinstripes but I have 2001 limited edition with factory stripes. I like the look a lot.
- Sat Aug 26, 2006 10:15 am
- Forum: R1150R (2001-2005)
- Topic: Starter interlock?
- Replies: 6
- Views: 2583
Starter interlock?
A few days ago I got on my 2001 R1100R and pulled in the clutch and thumbed the starter and nothing happened. I checked the kill switch (back down everyone, this is NOT another "to kill, or not to kill switch" threads), and it was in run mode and the dash lights were on and bright and I ha...
- Wed Jun 22, 2005 7:05 am
- Forum: Maintenence
- Topic: Ignition reset procedure
- Replies: 2
- Views: 8008
- Wed Jun 22, 2005 12:00 am
- Forum: Maintenence
- Topic: Ignition reset procedure
- Replies: 2
- Views: 8008
Ignition reset procedure
I searched a bit and came up empty screened. What is the procedure to reset the motronic after removing the CCP? I pulled the 5th fuse and then what? I remember something about blipping the thottle with the key on...