BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

All ABS lights out ride off test complete Bike back on road no issues so far Need to do some serious ridin now

Ok Update was unable to source the parts to repair my I-abs unit so had to source a different unit from a 2002 1150rt I have now done a successful DIY I-Abs transplant and so far so good self test passed all lights out ready for final rebuilt and drive off test fingers crossed. Was a long and windin...

I Have e-mailed Module masters and awaiting reply as to whether they can supply me with a motor from their donor units as I don't require a rebuild from them. just for your info we diagnosed a faulty motor by removing the cover on the face of the module with an tri-wing driver and inside are 2 small...

Does anyone know where I can source a replacement part for my 2001 r1150rt I-abs Module .Long story short ABS failure traced down to faulty servo motor all stripped down ready for replacement motor if I can get one from anywhere. Would appreciate any input thanks .

Post duly noted ,posted in wrong place apologies

Does anyone out there have a broken I-abs Modulator from a 2001 or there abouts R1150rt they would be willing to part with ?

With the combination of lights I have (GEN ON ABS Flashing 4hz) indication is that I have residual braking mode in one circuit and I believe it is the front I recall that when I put front wheel back on I may have trapped the front abs sensor wire between wheel and fork post ,can anyone tell me does ...

Thanks for your replies guys , I have been given a list of things to check over from fluid levels down to sensor gap so today its a case of start at the beginning and repeat actions checking everything inbetween on the way .Lets see how it goes .If no joy will have to get it on diagnostics and hope ...

I have a 2001 r1150rt which has been garaged for last 2 years awaiting new tyress so today I removed both wheels and take them for tyres, on replacing wheels I had to remove pads on front caliper to get wheel located properly .Job done until I started bike and ABs Brake failure lights appear . At fi...

Thanks for your inpute guy`s I will check them out cheers

Presumably the kill switch cut the engine when i pulled up and put down the stand so is working therefore why does it allow power to the starter ?
however i presume this is not normal so something is adrift somewhere

I too have the same problem i need more practice changing gear cant teach my wife to anticipate the ropey changes

I recently had a scary episode when i pulled over at a friends house and popped down the side stand while still in gear and engine cut out as it should .Having returned to the bike sometime later i put keys in and while stood at side of bike pushed starter switch forgetting it was still in gear and ...