BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

3mph and the abs front breaks makes a small sweaking gurgle noise when i am coming to a stop... it is not the servos, I am very familiar with the buzzing noise of the servos. The bike was pulled out of storage 2 days ago 7400 miles, maintenence at 6000, the brakes a bit unused. I have put one tank of gas through the machine so i would think that any residual brake dust or storage dust would be eliminated. I do alot of stop and go when i am going from home to work.. any thoughts? I will try to explain the noise it is a small one when you apply the front brake it comes from the right side of the front whell it sounds like nail on a chalk board. i lay off the break it stops and then reapplying it can start up again. But it only happens between 6 and 0 mph. I examined the entire wheel and discs and this has left me pondering................ any thought?

could be the pad has worn??

Or the pad is slightly glazed and is "squealing"

Pads should be new as of 6ooo mile tune probaly glazed..... but when i am going 30 and i jam them on i am not producing the noise. very slow stopping and it almost sounds like bearings