BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

Hi
I have a 99 R1100R.
The ABS light are flashing alternately. I used an LED and resistor to get the code out of the ABS ECU which pointed to a bad rear wheel sensor which I replaced.
However I cannot reset the Abs system with the switch and I cannot turn off the ABS with the switch.
Is it possible I might have a faulty switch?
Many thanks

See here http://www.wikihow.com/Reset-the-ABS-on ... Motorcycle
or here http://www.largiader.com/abs/absfault.html

Best regards
Oliver

Many thanks for the reply. I disovered the problem was a break in the lead between the ABS switch and the plug.

I have the same problem on my 98 R1100R.

I read somewhere that after battery replacement by Odyssey PC680 this was solved. These batteries are not cheap (approx. 120 USD), but seem to be really good.

Martin