centre stand fitting - idiot question
Posted: Mon Jun 12, 2006 1:26 pm
i purchased a centre stand for my rockster and just went out to fit it - but felt rather stupid with toolbox open that i couldn't work out where it goes....
i have the remus de-cat y-pipe i noticed too.... i thought this before as i couldn't see a cat under the bike but having laid on my back and inspected the underside i'm now sure.
so my question is - where does my centre stand bolt to? there appears to be 3 possible mounting sites - a bar that braces and holds the y-pipe, a black tube exiting from the rear sump area just in front of that and a shiny silver allen headed bolt just in front of that - but all of those would seem to foul the gear change lever with the sticky out push down bit of the stand when offered up in any of these positions.
am i really being stupid here? one of those moments perhaps?
also i have the remus revolution end-can. the baffle exit hole at the rear appears to have worn out its lower rivot mounting causing the baffle to be loose in the can - i can move it with my finger. having just searched this forum for an answer to the above question i noticed that this seems to be more common than one would hope for - what's the fix please? i don't really want to hear 'throw it away and buy a replacement' as it's in really good condition and i like the noise.
cheers for any help
paul
i have the remus de-cat y-pipe i noticed too.... i thought this before as i couldn't see a cat under the bike but having laid on my back and inspected the underside i'm now sure.
so my question is - where does my centre stand bolt to? there appears to be 3 possible mounting sites - a bar that braces and holds the y-pipe, a black tube exiting from the rear sump area just in front of that and a shiny silver allen headed bolt just in front of that - but all of those would seem to foul the gear change lever with the sticky out push down bit of the stand when offered up in any of these positions.
am i really being stupid here? one of those moments perhaps?
also i have the remus revolution end-can. the baffle exit hole at the rear appears to have worn out its lower rivot mounting causing the baffle to be loose in the can - i can move it with my finger. having just searched this forum for an answer to the above question i noticed that this seems to be more common than one would hope for - what's the fix please? i don't really want to hear 'throw it away and buy a replacement' as it's in really good condition and i like the noise.
cheers for any help
paul