BMW R1200R R1150R/T F800 K1200R R1100R/T R1250R RnineT Message Board

I have removed my little yellow box thingy under the seat in the fuse box . I have a 2002 1150R.
What should I expect to happen now.?????????

renagade

My 02 R has a nock on the right hand side of the engine when I start her up, can this be the right hand cam chain tens. or can the left hand tens. make the right side nock. I know you say''they all do that'' but it's not what i want when you are in a crowd telling every one how good beemers are and ...

Hi Guy's
You could of saved yourself a lot of trouble by just getting the roadster.R1140R

Hi Guy's
Yes I removed the can many miles ago . to day for the first time the can was off I noticed bad vibes at around 4k and above. I think the can will go back on very soon.

renagade

Thanks guy's
I will go and do it to morrow night.It is nearly midnight here in the UK


renagade

I have replaced my left side pannier for a 1150rt type ,now that my silencer (muffler ) as been replaced with a small pipe. What I want to do now is change the locking barrel so I have one key fits all.
HOW do you do this????????????????

renagade

Hi guy's
Any one in the uk got a seconhand (not bothered what condition ) lh 1150 rt pannier.
I have taken the pipe off and now want a full size pannier on the left to match the right,

renagade

Hi Guy's
This is for the guy's in the states. Have a look at the link I have posted and tell me what you think????

http://www.innovativebalancing.com/motorcycle.htm


Can you or have you heard of this ???????


renagade

Hi Guy's
I am a tall guy at 225 lbs. I was wondering what settings you have your front and rear dampers set at.????????

2002 1150r

Yes the tyres look nice but your new boots were pilot power mine are pilot roads. Do you think there should be a differance?????????????

Hi guy's Had a chat with Michelin Tyre plc to day and this is what I was told. BMW R1150R with Michelin Pilot Road tires would need to run with these pressures. Font 32psi rear 36psi These pressures are for solo and fully loaded . So who do you believe BMW or the people who make the tires Michelin??...

Hi Lad's and Lass's I too after a very fast long run found the oil stain on the rear drive unit. I call at my BMW dealer (Rainbow in the UK ) to puchase a seal. On telling the techy guy what my problem was he said '' You don't need a new seal as the new seal will go bad on you quite quickley all you...

Hi Branson I allso had this very slight leak on my 02 1150r,and was told by my dealer ( who is very reputable) that I am waisting my time putting a new seal in as it will :he said MIST again: he says that all the rear oil seals do the same . I was told to take off the plastic tie raps and put on s/s...

Hi Guy's My 1150R rattles for a few seconds on start up on the right hand ( from the seat of the bike )side of the engine. is this pending doom or can this be easly fixed. Also does the BMW oil filter have a non return valve in side it to stop the oil from draining off back to the sump when it is sw...

Hi Guy's My 1150R rattles for a few seconds on start up on the right hand ( from the seat of the bike )side of the engine. is this pending doom or can this be easly fixed. Also does the BMW oil filter have a non return valve in side it to stop the oil from draining off back to the sump when it is sw...

how dificult is it to change the rear oil seal in the final drive housing????? i mean the small one just under the rubber boot.

I am taking 10 bikes with me over to Italy in August. ( I will be riding only my beemer ) I would like to go down via germany,austria and switserland,and come back to the UK via the Route Napolian in France. Has any one done the run to Italy from the UK and if so I would like any sudgestions you mig...

hi
DJ Downunder
If you could that would be great. I mean post the picy.

renagade

Hey Guy's
I have been told that because my helmet is 5 years old that it needs replacing as they go brittle and are no good in a smash.
What do you think. How offern do you change your lids.

Paul

Hey Guy's
What do you think to the idea of a balancing pipe fitted to the nipples on each
throttle body. I know I have balanced my throttle bodies very well but ..........
Would it do any arm to the runnong of the bike.
By the way it ia a 1150R

Paul