How d'ya like this front end stand?!
Posted: Mon Nov 14, 2005 12:36 am
OK. I've been searching for a front end stand for my tire eater. I was about to pop for a Pitbull front (I have the Pitbull rear) but found the left mount point comes dangerously close to the ABS sensor. Instead, I opt for the Kern-Stabi stand - which is designed for the KR/KS. I just received it am very pleased with its simplicity, ease of use, and adjustability.
http://www.mv-motorrad.de/cosmoshop/lsh ... 63251,.htm
Then, I happen upon this for $26.00!!!
That's cheaper than the special 22mm hex key I needed to buy to remove the front wheel!
Touratech's description:
When on the centerstand, the R1200GS is very heavily weight-biased to the front. Even with the front wheel removed, it is impossible for one person to hold the front forks off the ground while installing the wheel.
The removal-jack folds in half for easier storage. Includes a plate for soft-surfaces that doubles as a brown bottle opener for after the job is done. And it can be used for a kickstand plate for parking in sand or hot asphalt.
Could this item possibly work for the KR? Very cool if in fact it'll work on the K...
http://www.mv-motorrad.de/cosmoshop/lsh ... 63251,.htm
Then, I happen upon this for $26.00!!!
That's cheaper than the special 22mm hex key I needed to buy to remove the front wheel!
Touratech's description:
When on the centerstand, the R1200GS is very heavily weight-biased to the front. Even with the front wheel removed, it is impossible for one person to hold the front forks off the ground while installing the wheel.
The removal-jack folds in half for easier storage. Includes a plate for soft-surfaces that doubles as a brown bottle opener for after the job is done. And it can be used for a kickstand plate for parking in sand or hot asphalt.
Could this item possibly work for the KR? Very cool if in fact it'll work on the K...
...that'd be a bit of a pain. 